Fire Harm Cleanup

Rate this Entry
"You have had a fire. The fire department has come, put the fire out and all you see is 1 massive mess. Upon closer investigation questions come.
I. What strategy do we use to remove the soot and charcoal to evaluate the harm?
- High pressure water blasting leaves behind water in electrical elements, equipment and insulation, if not correctly removed will trigger unwanted corrosion and rot, growing cleanup, harm and extended term upkeep costs.
- Soda blasting leaves water and soda behind, which calls for extra cleanup, rising cleanup, damage and long term maintenance costs.
- Sand blasting leaves abrasive blast media behind, which if not cleaned up effectively continues to cause damage in electrical components, gears and bearings. It continues to fall from horizontal surfaces, cracks and beams years right after the job is completed, increasing cleanup, damage and extended term
maintenance fees.
- Dry ice blasting is the ultimate surface cleaning process, it leaves no secondary waste stream behind. The only cleanup immediately after the dry ice blasting job is completed is the removal of the debris triggered by the fire.
II. How do we remove the soot, charcoal and smoke film from masonry and steel surfaces?
- Again this is an outstanding application for dry ice blasting. Watch the movie clips on our web site to see how dry ice blasting cleans soot, smoke and charcoal from different types of surfaces.
III. Will we be able to remove that awful smoke smell?
- The removing of the smell is accomplished by removing the smell source and/or sealing the smell source to encapsulate it. Dry ice blasting removes the soot, charcoal and smoke film, which is the smell source, from accessible regions.
- During a fire air currents carry smoke and soot into cracks, openings and places not in close proximity to the fire itself, further cleaning and/or sealing of these places and inaccessible areas might be necessary.
IV. Can we achieve our cleanup with out adding hazards to our environment?
- Dry ice blasting is secure and environmentally friendly. Dry ice is pure CO2 in its solid state, it is in its gaseous state in the air around us. When we inhale our bodies use the oxygen and we exhale CO2. Green plants take CO2 from the air and give off oxygen.
- Dry ice blasting is non-toxic, non-conductive and there is no employee exposure to hazardous cleaning chemicals or solutions. Dry ice blasting meets the guidelines of the USDA, EPA, and the FDA. mold cleaning"
Tags: None Add / Edit Tags